Filter
Top Products
12
IMPORTANT: ALWAYS INSIST ON GENUINE AQUACHLOR REPLACEMENT PARTS. If it is
necessary to replace the Electrolytic Cell, beware of “look alikes”. Only the Genuine Aquachlor
Cell is designed and warranted to operate with the Aquachlor Power Supply.
SERIOUS DAMAGE MAY RESULT TO THE ELECTRONICS INSIDE THE UNIT IF COPY
ELECTRODES ARE USED AND WILL VOID WARRANTY.
PATENT INFORMATION: Aquachlor Self Clean Sytems are protected by Australian Standard
Patent Number 684550.
Consult your local Aquachlor Dealer for further information.
TROUBLE SHOOTING:
No Chlorine Production - Check for
1. Main power outlet switched off
2. Chlorinator not plugged into main outlet
3. Pump not plugged into Chlorinator
4. Time Clock set to Off position/Power switch turned Off
5. System Control turned to mid setting
6, Chlorinator 3 amp fuse blown
7. Dirty Cell
8. Filter needs backwashing
9. Gas Sensor not connected
10. Running times incorrect
11. Main house fuse blown
12. Pump motor faulty
Low Chlorine Production - Check for
1. Dirty Cell - clean if required
2. Filter needs backwashing
3. Display not at correct production level/Cell failing
4. Winter Mode turned On
5. Pool stabiliser too low
6. pH too high
7. Salt level too low
8. Aquachlor running time inadequate
Technical Information (specifications subject to change without notice):
Model
Output 100%
(grams per hour)
Fuse
Approximate
Power
Consumption (W)
C260
20
3A
200
C390
30
3A
300
C520
40
5A
400
SC250
16
3A
160
SC330
24
3A
240