Filter
Top Products
Juice Extractor
Check to be sure that the Juice Cup is in place
and feed material to be processed into the Inlet
Chute at a moderate and steady rate. Use the
Pusher as required to clear the Chute. Avoid
excessive force when using the Pusher. A
moderate, steady pressure is all that should be
required. Too much pressure may cause the
material to jam the Inlet Chute, or cause
distortion of the Cutter/Strainer Assembly.
Note: If the Chute does become jammed
from excessive force, proceed as outlined
under (B) following, clearing the chute before
reassembling the parts.
Note: Never use fingers or any other object
other than the Pusher to clear the Inlet
Chute. If the food cannot be dislodged, turn
the motor off. Unplug power cord from
outlet before proceeding.
Remove the Cover from the Juice Extractor
assembly, and use a rubber spatula or long
handled wooden spoon to clear the Inlet Chute.
Continue processing until one or more of the
following conditions occur:
(A) If the Juice Cup is full before all the material
is processed, push the power button ‘OFF’
and allow the Juice Cup to remain in place
until the Motor stops and juice stops flowing.
Transfer the juice to a separate container.
Replace the Juice Cup or push the power
button ‘ON’ to continue processing.
(B) If the Pulp Collector is full before all the
material is processed, push the power button
‘OFF’, and allow the Juice Cup to remain in
place until the Motor stops and juice stops
flowing.
Unplug power cord from outlet before
proceeding.
Remove the Juice Factory Assembly and
dismantle parts as outlined under ‘Disassembly
Instructions’.
Remove pulp from the Pulp Collector.
Reassemble parts as outlined under ‘Assembly
Instructions’.
5
How To Use Your Juice
Factory
The Juice Factory is made for the express
purpose of extracting flavourful vitamin and
mineral filled juices of raw fruits and vegetables
by means of centrifugal force.
Operation
Before first using your Juice Factory, carefully
wash and dry all parts that will come into contact
with food.
Prepare material to be processed by washing
thoroughly and peeling as required. Remove all
pits, stones and large seeds.
Cut large fruits or vegetables into small pieces
when using Inlet Chute.
Plug cordset into a regular 240V earthed outlet.
Push power button ‘ON’. To adjust speed push ‘I’
for a slow setting and ‘II’ for a faster setting.