Filter
Top Products
4517 BS ACSeries specs V3 24/6/05 10:52 AM Page 14
Australia
Moffat Pty Limited
Victoria/Tasmania
740 Springvale Road
Mulgrave, Victoria 3170
Telephone 03-9518 3888
Facsimile 03-9518 3833
vsales@moffat.com.au
New South Wales
Telephone 02-8833 4111
nswsales@moffat.com.au
South Australia
Telephone 03-9518 3888
vsales@moffat.com.au
Queensland
Telephone 07-3630 8600
qldsales@moffat.com.au
Western Australia
Telephone 08-9562 0263
jberent@moffat.com.au
New Zealand
Moffat Limited
Christchurch
Telephone 03-389 1007
sales@moffat.co.nz
Auckland
Telephone 09-574 3150
sales@moffat.co.nz
Australia
www.moffat.com.au
New Zealand
www.moffat.co.nz
Printed in China
© Copyright Moffat Ltd
Moffat/4517-E21/BH/3.5M/6.05
Dimensions
Width 950mm
Depth 825mm
Height 1950mm
Weight 310kg
Packed Dimensions
Width 1130mm
Depth 1050mm
Height 2220mm
Weight 400kg
Shelves
1/1 GN 20
Shelf Spacings 67mm
Installation requirements
(for precise installation
instructions, please refer to the
unit’s installation manual).
Power connection requirements
Multi pole circuit breaker and all
pole disconnection isolator switch
installed near the appliance.
Supply line voltage;
400-415V ~ 50Hz, 3P+N+E
Special voltage options available
on request.
Power Connection
Total (kW) 31.8
Convection power (kW) 30
Rated Current (A) (400V) 45
IPX5 spray-proof and hose proof.
Installation clearances
- rear 25mm
- right 500mm*
- left 50mm
*Clearance required on fixed
installations for service
accessibility.
If heat sources are located near
the RH side of the AC combi,
ensure that a minimum distance
of 400mm is maintained.
Install in accordance with local
body regulations only on horizontal
surfaces and not against
combustible walls.
Water connection requirements
- Cold water
- Flow pressure (2 to 6 bar)
- soft water connection*
- shut-off valve with return flow
inhibitor and dirt filter
- water supply R3/4
- R50 waste water connection
(*Water softener may be required.
Please refer to installation manual
for water treatment values.)
In line with policy to continually develop
and improve its products, Moffat Limited
reserves the right to change
specifications and design without notice.
TECHNICAL SPECIFICATION SHEET FOR
BLUE SEAL ELECTRIC COMBI STEAMER
AC SERIES E21AC DD 20 x 1/1GN CAPACITY
A = WATER CONNECTION R
3
/4
(SOFTENED WATER) refer to installation
manual for water treatment values.
B = WATER CONNECTION R
3
/4
C = DRAIN CONNECTION Ø50
D = ELECTRICAL CONNECTION ENTRY
E = HIGH/LOW PRESSURE RELIEF VENT
F = OVEN VENT Ø80
Optional Extras
SC Core temperature probe
KST21 Extra roll-in trolley to suit 21AC DD
KPT21 Plate banqueting trolley to suit 21AC DD / 60 plates 310mm
CPT21 Thermal cover for plate banqueting system to suit 21AC DD