Filter
Top Products
4
Electrical requirements
Check that the voltage on the rating plate of your
appliance corresponds with your house electricity
supply which must be A.C. (Alternating Current).
If the socket outlets in your home are not suitable
for the plug supplied with this appliance, the plug
should be removed and the appropriate one fitted.
Note: The plug removed from the mains lead, if
severed, must be destroyed as a plug with bared
flexible cord is hazardous if engaged into a live socket
outlet.
WARNING: THIS APPLIANCE MUST BE
EARTHED
Should the fuse in the 13 amp plug require
replacement, a BS1362 13 amp fuse must be fitted.
Features of your toaster
⁄ Variable width bread slots
¤ Electronic variable browning control
‹ 2 position function switch
› Frozen bread button
fi Cancel button
fl Bread carriage lever/hi lift for small items
‡ Removable crumb tray (at rear)
· Cord storage (on base)
Instructions for use
1 Before plugging in ensure that the carriage lever
fl is in the upper position.
2 Use your toaster once without bread. This will
pre-heat the new elements and burn off any dust
which may have accumulated during storage.
3 Select the desired level of browning on the
browning control ¤ marked 1 to 8. You will need
to vary the setting according to the moisture
content and thickness of bread. For best results
ensure that the bread slices are of even thickness,
freshness and size. The variable width bread slots
will accept thicker or thinner bread than a
conventional toaster. Remember that stale bread
toasts more rapidly than fresh and thin bread
toasts quicker than thick. See the ‘additional
points’ section for more information.
4 After selecting the desired setting, place your bread
in the slots and depress the bread carriage lever fl
downwards until it locks.
Note: The bread carriage lever will not stay down unless
the toaster is plugged in and wall switch is on.
5 When the toast is cooked, it will pop-up
automatically ready for removal from the slots.
The bread carriage lever will have returned to its
upper position and disconnected the element,
ready for the next toasting.
• If the first slices are not dark enough turn the
browning control to a higher setting.
• If the first slices are too dark turn the browning control
to a lower setting.
• When toasting two slices, put the bread in the
two outer slots for best results. One side may
appear to be a darker colour than the other. This
is quite normal and is not a fault.
• If the bread in your toaster becomes jammed,
disconnect your toaster at the socket, allow it to
cool, then remove the bread.
• When not in use, switch
your toaster off at the mains
and remove the plug from
the socket. DO NOT
WRAP THE CABLE
AROUND THE MAIN
BODY OF THE TOASTER
DURING OR
IMMEDIATELY AFTER USE.
THE CABLE STORAGE
AREA UNDERNEATH THE
TOASTER SHOULD BE USED.
Please read before use, taking careful note
of points 1 to 3
›
‡
·
¤
⁄
fi
‹
fl
Control Panel
¤
‹
›
fi