Filter
Top Products
44
BEFORE FIRST USE
• Before using the toaster for the
first time, operate the toaster
without bread.
• As with all new electric heating
elements, your toaster emits a
‘new’ smell when it is first
switched on. This is quite normal
and not a cause for concern.
OPERATING THE
APPLIANCE
The toaster has two sides with
controls repeated for each half.
Each half can be used together
or independently.
1 Select the desired level of
browning on the browning
control dial fl.
2 After selecting the desired level,
place your bread in the slots ⁄
and depress the bread carriage
lever downwards until it locks.
3 After the set time has been
reached, the bread will pop up
automatically - ready for removal
from the slots. The bread
carriage lever will have returned
to it’s upper position and the
heating element will have
switched off.
WARNING: Do not wrap the
cable around the main body
of the appliance during or
after use.
ADDITIONAL
FEATURES
Using the re-heat
button
If your toast has popped up and
gone cold, the toaster offers a
re-heat facility. To use, depress
the relevant bread carriage lever
and press the re-heat button ›
immediately. The button will
illuminate and the toaster will
operate for a short period
re-heating the bread.
Using the
frozen button
To toast frozen bread, do not
adjust the browning control from
your normal setting. Place the
bread in the bread slots as
normal, and press the frozen
button ‹.
Using the pause
and check /
cancel button
If you wish to check the process
of the toasting cycle, press the
Pause and check / cancel
button fi. On pressing the
button, the bread carriage will
pop up automatically for you to
check. This action will pause the
heating elements, during this
period, the function button lights
will flash. If you have achieved
the desired level of browning,
remove the toast from the
toaster. If longer toasting is
required, depress the bread
carriage lever within 5 seconds
to resume the toasting cycle at
the same stage it was at when it
was paused.
Hints and tips
• In order to achieve uniform
browning, we recommend you
wait a minimum of 30 seconds
between each toasting, so that
the control can be automatically
reset.
• If toasting one slice only, you may
need to adjust the browning
control to a slightly lower setting.
• Please note: you will also notice a
slight variation in toast colour on
one side of a single slice.
• Stale bread toasts more rapidly
than fresh bread. Therefore, the
browning control should be set at
a lower setting than usual.
• All sorts of bread can be used, as
well as teacakes, small rolls etc.
However, slices should not be so
thick as to cause burning or
jamming within the bread slots.
UUKK HHeellpplliinnee 00884444 887711 00995577 RReeppllaacceemmeenntt PPaarrttss 00884444 887733 00772233 IIrreellaanndd HHeellpplliinnee 11880000 440099 111199
44333 rev1 20/3/08 11:35 Page 6