Filter
Top Products
44
UUKK HHeellpplliinnee 00884444 887711 00995522 RReeppllaacceemmeenntt PPaarrttss 00884444 887733 00771188 IIrreellaanndd HHeellpplliinnee 11880000 440099 111199
44
BEFORE FIRST USE
Refer to the assembly sequence
on this page.
When unpacking the fryer, make
sure all packaging material is
removed.
WARNING: make sure that
your fryer is disconnected
from the electricity supply.
Please note: Remove the filter
from the lid before washing the
lid.
Remove the frying basket, non
stick bowl and lid, and wash
these by hand in hot soapy
water. Please note: do not leave
in water to soak for a long
period of time.
Dry all parts of your fryer
thoroughly and replace the
bowl, basket and lid.
Replace the bowl with the
max/min lines to the rear.
(Please follow the cleaning
instructions).
WARNING: Do not immerse
the main unit in water.
OPERATION
Lid operation
Press the lid release button
down and in, the lid is spring
loaded and will rise up on it’s
own A.
In the upper position, the lid will
lift out of it’s guides at the back
for easy cleaning. To replace,
locate in the guides and slide
back into position B.
Close the lid by pressing down
in the centre and ensure the
locking catch „ is fully
engaged.
Basket operation
Pull the basket handle to the
horizontal position to raise the
basket C.
Location of basket to
drain
The basket can be raised into
the rest/drain position or
removed completely.
Take the basket out of the fryer
and place the required amount
of food in the basket. (Refer to
page 8 for quantities).
Lift the basket back into the
rest/drain position, then close
the lid D.
Assembly /
Disassembly
sequence
The fryer has to be
disassembled and assembled
following this procedure.
• Open the lid and remove.
• Remove the basket.
• Lift out the tank.
Assembly is the reverse of the
above process.
Replacing the bowl
Ensure the bowl contacts are
dry before replacing E.
Ensure the max and min lines
on the bowl are at the back of
the fryer.
Filter
Press the locking tab back and
lift out the panel F. The filter
cannot be cleaned and should
be replaced after 15 frying
sessions. Always replace with
the black side facing upwards.
Remove the filter before
washing the lid.
Cord storage
Wind the cord onto the cable
wind at the rear of the fryer G.
Fully unwind the cord before
use.
A
C
D
E
F
B
G
45362 rev1 24/4/08 12:10 Page 4