Filter
Top Products
Morphy Richards products are intended for household use only.
Morphy Richards has a policy of continuous improvement in product quality and design.
The Company, therefore, reserves the right to change the specification of its models at any time.
Morphy Richards Limited, Mexborough,
South Yorkshire, England, S64 8AJ
444/8502/15 Rev 1
Using your re-heat button
If you toast has popped up and gone cold,
the toaster offers a re-heat facility. To use,
depress the bread carriage lever and press
the re-heat button immediately . The
button will illuminate and the toaster will
operate for a short period re-heating the
bread.
Using the high lift release
If small bread is toasted, this may be
removed more easily by lifting the bread
carriage lever.
Cleaning and MaintenanceCleaning and Maintenance
Cleaning and MaintenanceCleaning and Maintenance
Cleaning and Maintenance
1 After use and before cleaning, switch off
at the mains, remove the plug from the wall
socket and wait for the toaster to cool.
2 Wipe the outside of the toaster with a damp
cloth only and dry with another cloth or
tissue.
• NEVER use metal polish or coarse scouring
agents and never immerse your toaster in
any sort of liquid.
• NEVER use any pointed or sharp articles
for cleaning the inside, otherwise the
heating element will be damaged.
• NEVER use a brush or push your fingers or
metal objects down the slots.
Crumb trayCrumb tray
Crumb trayCrumb tray
Crumb tray
Crumbs will accumulate in the crumb tray
and could catch fire if not emptied periodically.
When the toaster has cooled down completely,
tap the sides of the case lightly to dislodge any
crumbs lodged in the toasting chamber and pull
out the crumb tray . Empty the tray and
replace it.
Never operate the
toaster without
the crumb tray
fitted.
Additional pointsAdditional points
Additional pointsAdditional points
Additional points
• In order to achieve uniform browning, we
recommend you wait a minimum of 30
seconds between each toasting, so that the
control can automatically be reset.
• If toasting one slice only, you may need to
adjust the browning control to a slightly
lower setting.
• Note you will also notice a slight
variation in toast colour on one side of a
single slice.
• Stale bread toasts more rapidly than fresh
bread. Therefore, the browning control
should be set at a lower setting than usual.
• All sorts of bread can be used as well as
teacakes, small rolls etc. Slices should not
however be so thick as to cause burning or
jamming within the bread slots.
• When toasting 2 slices it is recommended
they are of equal size and freshness.
Allow the toaster to cool fully before putting
away.