Filter
Top Products
Slicing and grating blades
The blades Á, È, Í and Î are stored in
the tool storage pod Ï. The blade holding
disk Ë is also the lid of the pod. These
blades locate in the upper position of the tool
adaptor.
1 Choose which blade you wish to use and
place it into the plate holding disk E.
•Blades can be removed from the blade
holding disk or the lid by pushing up from
behind E.
2 Use the two finger holes in the plate
holding disk, locate the disk onto the tool
adaptor inside the bowl F.
3 Replace the bowl lid.
4 Insert the food to be sliced or grated into
the the pusher tube.
5 Insert the pusher into the pusher tube G.
6 Switch on and process the food by
pushing the food onto the rotating blade
by pushing with the pusher tube.
•To feed in large pieces of food use the
large pusher (with the small pusher locked
inside).
•To feed in small amounts of ingredients,
liquids and oils, remove the small pusher
from the inside of the large pusher by
unlocking it. Feed the food through the
tube of the large pusher with the small
pusher.
WARNING: never insert your fingers
into the pusher tube.
5
ED
F G
8780 Food processor ib.QX4 28/4/04 4:53 pm Page 5