Filter
Top Products
5
Assembling the blender
1 Once the blender is charged, fit the
blender leg by attaching it into the
location slot on the blender body.
C
Press until it clicks into place.
• If the leg is not fully engaged, rotate it
round and try again.
WARNING: Do not touch the blade
or hold the blender leg at this end
when fitting to the body.
WARNING: To remove the blender
leg, hold blender in a position so you
cannot press the operating button, grip
shaft of blender leg, press the release
button and pull apart.
To disassemble hand
blender
1 To remove the blender leg, hold the
blender in a position so that you cannot
press the operating button. Grip shaft of
blender leg, press the release button and
pull apart.
D
WARNING: When the blender is not
in use, fit the blade cover to the leg for
safety.
Using the blender
1 To operate press the on/off button and
begin to blend. E
• For perfect blending use a ‘plunging
action’ this will allow the food to be
pulled into the blade and dispersed
through the exit vents.
• Keep the head of the blender beneath
the food surface to prevent splashing.
• The hand blender can be used with a
beaker or a bowl.
WARNING: Never use your appliance
in a hot saucepan transfer to a bowl,
allow to cool before blending.
IMPORTANT: Your hand blender is
designed for intermittent use only. Do not
use non-stop for more than 1 minute. Allow
to cool down for a minimum of 5 minutes
before further use.
CE
D
48965 Rev 1 13/4/04 3:47 PM Page 5