Filter
Top Products
5
6 Place the filter holder on the
brewing head and position the
handle so it points to the left.
Ensure the filter holder is flat against
the brewing head and turn the handle
towards the right
as far as it will
go. Note: Do not overtighten.
7 Place 1 or 2 pre-heated cups
below each of the holes in the filter
holder and
I
. When the coffee
maker is at the correct temperature
the orange ‘warm up’ light will go out.
8 Turn the selector dial to the
coffee setting. You will hear the
machine make a pumping noise, this
is normal.
9 Once the cups are filled to the desired
level turn the selector dial to the ‘0’ off
position. Water will still filter through
for approximately 8 seconds after the
machine has been turned off.
10 Remove the filter holder and filter by
turning the filter holder handle to the
left.
11 To remove the used coffee grounds
from the filter, push the filter lock
forward over the edge of the filter and
turn the filter holder upside down.
Gently tap out the coffee.
12 Once the orange ‘warm up’ light goes
out your machine is ready to make the
next espresso.
Steam function
The froth attachment makes it easy to
produce frothy milk for cappuccino.
1 Before using the steam nozzle,
remove the filter holder.
2 Attach the froth attachment
to the
end of the steam nozzle .
IMPORTANT: For the froth enhancing
attachment to work you must ensure that
it is pushed firmly onto the steam nozzle.
3 Fill the water reservoir with cold tap
water.
4 Turn the unit on. The red ‘power’ light
and orange ‘warm up’ light will both
illuminate.
5 Swing the steam nozzle with the froth
attachment to the side of the machine.
I