Filter
Top Products
Using
Filling the kettle
1 Wherever possible fill through the spout,
as this helps to free the filter from
limescale build-up.
• The integrated water level indicator
allows you to easily see the amount of
water in the kettle.
• Always ensure that the level of water in
the kettle is filled to at least the minimum
level shown on the water gauge. Should
your kettle not have a water gauge,
always ensure that the element is
covered.
• Boil only as much water as you need as
this saves electricity.
2 Place the kettle on the base unit,
ensuring the kettle locates on to the
360˚ connector.
• The 360˚ connector allows the kettle to
be located at any position. - ideal for left
and right handed users and convenient
positioning on worktop.
3 Plug in and switch on at the wall socket.
4 Switch the kettle on. The ‘power on’
neon, will light up.
5 When the water boils the kettle will
switch off automatically.
• If you are using the kettle for the first
time, pour away the boiled water and
refill.
6 Lift the kettle from the base unit by the
handle ensuring you hold the kettle level.
• To re-boil, switch to ON again. If the
kettle has just switched off wait a minute
or so before switching it back on again.
• If you do not put in enough water, or
switch on the kettle when it is empty, the
safety cut-out will switch off the power
automatically. If this happens, refill and
wait a few minutes for the element to
cool, then use as normal.
Filter removal
1 Open the lid.
2 Lift the filter upwards from its location
using the tab provided.
3 To refit the filter, slot it into the side wall
guides and press down firmly. Ensure
the filter is correctly located into the
central guide.
WARNING: Unless the filter is fitted
correctly, the kettle lid may not close and
lock securely.
4
Filtermaster III Rev 2 14/8/03 4:56 pm Page 5