Morphy Richards Reflect glass kettle Hot Beverage Maker User Manual


 
Using
1 Wherever possible fill through the spout,
as this helps to free the filter from
limescale build-up.
The kettle can also be filled through the
lid. Use the lid release button
¤ to
open.
The clear glass body of the kettle allows
you to easily see the amount of water in
the kettle.
IMPORTANT : When filling from a tap,
care must be taken to avoid striking the
glass body on the tap.
Always ensure that the level of water in
the kettle is filled to at least the minimum
level shown on the water level indicator.
Boil only as much water as you need as
this saves electricity.
2 Place the kettle on the base unit,
ensuring the kettle locates on to the
360˚ connector.
The 360˚ connector allows the kettle to
be located at any position. - ideal for left
and right handed users and for
convenient positioning on worktop.
3 Plug in and switch on at the wall socket.
4 Switch the kettle on. The power on
neon, will light up.
5 When the water boils the kettle will
switch off automatically.
If you are using the kettle for the first
time, pour away the boiled water and
refill.
6 Lift the kettle from the base unit by the
handle ensuring you hold the kettle level.
To re-boil, switch to ON again. If the
kettle has just switched off wait a minute
or so before switching it back on again.
If you do not put in enough water, or
switch on the kettle when it is empty, the
safety cut-out will switch off the power
automatically. If this happens, refill and
wait a few minutes for the element to
cool, then use as normal.
Filter removal
1 Open the lid using the release button ¤.
2 Lift the filter upwards to remove.
3 To refit the filter, slide it into the side
guides of the filter holder until it clicks
into place. Ensure the filter is correctly
located.
WARNING: Unless the filter is fitted
correctly, the kettle lid may not close and
the kettle may not switch off after boiling.
4