Moyer Diebel 401-LTM2 PLUS Dishwasher User Manual


 
5
INSTALLATION
INSTALLATION
Unpacking
WARNING:
Care should be taken when lifting the machine to prevent damage.
1. Immediately after unpacking your machine, inspect for any shipping damage. If damage is
found, save the packing material and contact the carrier immediately.
2. Remove the dishwasher from the skid. Adjust the feet if required, then move the machine to
its permanent location.
3. Level the machine (if required) by placing a level on the top of the machine and adjusting
the feet. Level the machine front-to-back and side-to-side.
CAUTION:
After locating your machine, the installation must meet local health codes. An example may
be to seal your machine to the floor using a good grade of silicone sealant.
Electrical Connections
WARNING:
Electrical and grounding connections must comply with the National Electrical Code
and/or Local Electrical Codes.
WARNING:
When working on the dishwasher, disconnect the electric service and tag it to indicate work
is being done on that circuit.
1. The electrician should compare the electrical specifications on the machine electrical rating
label (located on the lower left front panel) to the electrical power supply before connecting
the machine to the incoming service at a fused disconnect switch.
NOTE:
The 208-240V/60Hz/1PH electrical supply service for this machine must be a
3-wire plus ground service.
2. On the 208V-240V models, a terminal block is provided on the left front side of the
machine (located behind the front panel) for electrical service connections. A fused
disconnect switch or circuit breaker (supplied by user) is required to protect each power
supply circuit.
3. On 115V models, your machine is already equipped with a 4-foot power cord and plug
suitable for 115V-15A service.
!
!
!
!