Mr. Coffee 7985-33 Coffeemaker User Manual


 
setting up
Setting Up
Setting the Clock and Delay Brew Time
On programmable models (7984-33, 7985-33, 7988-33 only)
To Set the Clock:
1. Plug the power cord into a standard electrical
outlet. The clock will flash on the control panel
to indicate that the time has not been set yet.
2. Press and hold the HOUR and MINUTE buttons
until you reach the current time. The AM or PM
indicator will light at the top of the display
(Figure 1 and 2)
The clock is now set!
NOTE: Pressing any button before setting the
clock will cause the clock to start keeping time
from 12:00 a.m. You must set the clock if you
want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is on the clock mode, simply press
the SET DELAY button (Figure 3) and, while the
DELAY BREW yellow light is flashing, set the brew
time by pressing the HOUR and MINUTE buttons
(Figure 4). The AM or PM indicator will light at the
top of the clock display.
Within a few seconds the display will change to the
current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle, see
the “Brewing Coffee Later” section.
To check the programmed time, push the SET
DELAY button. The display will show the time
you have programmed the coffee to brew. If you
press the SET DELAY button again or wait a few
seconds, the display will switch back.
9
Figure 1
Figure 2
Figure 3
Figure 4