Filter
Top Products
Step 3: Close the lid, and perform a brew into the ceramic
mug without adding a K-Cup
®
Pack.
Step 4: Pour the contents of the ceramic mug into the Hot
Water Tank, careful the liquid will be hot, close the
lid. Start a brew but power off the Brewer just after it
starts to dispense and then allow it to sit for at least
30 minutes.
Step 5: After the prescribed period of time, perform a brew
without adding a K-Cup
®
Pack. Empty the contents of
the ceramic mug into the sink, be careful as contents
may be hot.
Step 6: Fill the Hot Water Tank with 8 ounces of bottled
water, close the water fill lid, place a cup on the Drip
Tray Plate and perform a brew.
Step 7: Repeat Step 6 three times using bottled water (with
no K-Cup
®
Pack in place) to cleanse the Brewer
plumbing and get rid of any residual taste from the
vinegar. The Brewer is now ready for normal use
again.
PROBLEM SOLUTION
Brewer does not
have power
Make sure the Power Button is pressed
and is illuminated.
Plug Brewer into an independent outlet.
Check to be sure that it is plugged in
securely.
Plug into a different outlet.
Brewer will not
brew when used
for the first time
If Brewer is cold/frozen, wait for at least
two hours for it to reach room tem-
perature before powering on.
Brewer will not
brew
Check to make sure there is water in
the Hot Water Tank.
Brewing a partial
cup
The Exit Needle may be clogged (refer
to page 12).
Clean K-Cup
®
Pack Holder if necessary
and rinse under faucet (refer to page 12).
De-scale the Brewer (refer to page 13).
If you have repeated the de-scale
procedure on your Brewer two times
and the Brewer is still not brewing,
contact Customer Service.
TROUBLESHOOTING YOUR SINGLE SERVE BREWER
Beyond these recommended cleaning and maintenance
procedures this Brewer is not user serviceable, for service
please refer to the Warranty section in this guide.
14 15
BVMC-KG2_11ESM1.indd 15-16 2/1/12 2:50 PM