COFFEEMAKER FEATURES AND BENEFITS
Your new MR. COFFEE
®
coffeemaker has the following features:
• Brewing Capacity – 10 Cups – thermal carafe
• Removable Filter Basket – The filter basket pulls out for fast and easy cleaning and
filling.
• Removable Water Reservoir – Allows you to take the water reservoir out for easy
filling. Prevents the thermal decanter from cooling down prior to brewing cycle.
• Pause ‘n Serve – Can’t wait for the coffee to finish brewing? The Pause ‘n Serve
feature allows you up to 30 seconds to pour a cup of coffee while the coffeemaker
is still brewing. Carefully remove the decanter and the Pause ’n Serve feature will be
automatically activated, temporarily stopping the flow of coffee into the decanter.
• Dim Display – Save energy by reducing the brightness of the display.
• Water Filtration System – Great tasting coffee begins with great water! Improves
the taste of your coffee by removing 97% of the chlorine from the water you use for
brewing.
• Cord Storage – Safely stores excess cord to keep your countertop neat.
• Programmable Controls:
– Clock – The clock serves as a handy kitchen clock and allows you to set the Delay
Brew feature and functions as the FRESH BREW™ TIMER feature.
– Fresh Brew™ Timer feature – Lets you know how long your coffee has been
waiting for you.
– Audible Signal – Alerts you at the end of a brew or clean cycle.
– Delay Brew – Would you like to wake up to a fresh pot of coffee? The timer
allows you to preset when you would like the coffeemaker to automatically begin
brewing your coffee, up to 24 hours in advance.
– Special Cleaning Cycle – Enables you to easily maintain and clean mineral
deposits from your coffeemaker.
CLEAN YOUR COFFEEMAKER BEFORE USING THE FIRST TIME
Make sure your first cup of coffee is as good as can be by cleaning your MR. COFFEE
®
Coffeemaker before its first use. Just follow these simple steps:
1. Wash the decanter, decanter lid and the filter basket in a mixture of mild detergent
and water. Rinse each thoroughly (please refer to the Parts Diagram).
2. Replace all the parts and attach the water reservoir. Then, run a brew cycle with
water only, without adding coffee and coffee filter.
3. When brewing is complete, turn your coffeemaker off, discard the water in the
decanter and rinse the decanter, decanter lid, and filter basket.
Your coffeemaker is now ready to use. Enjoy it!
SETTING THE CLOCK AND DELAY BREW TIME
To Set the Clock:
1. Plug the power cord into a standard electrical outlet. The clock
will flash on the control panel to indicate that the time has not
been set yet.
2. Press and hold the HOUR and MINUTE buttons until you reach
the current time. The AM or PM indicator will light at the bottom
of the display (Figure 1).
The clock is now set!
NOTE: Pressing any button before setting the clock will cause the
clock to start keeping time from 12:00 a.m. You must set the clock
if you want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode, simply press the SET DELAY
button (Figure 2) and, set the brew time by pressing the HOUR
and MINUTE buttons (Figure 3). The AM or PM indicator will light at
the bottom of the clock display.
Within a few seconds the display will change to the current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle, see the Brewing Coffee
Later section.
To check the programmed time, push the SET DELAY button.
The display will show the time you have programmed the coffee
to brew. If you press the SET DELAY button again or wait a few
seconds, the display will switch back.
FIGURE 1
FIGURE 3
FIGURE 2
6 7