Filter
Top Products
Before
Using Your
Mr.
Coffee
Espresso
Maker
Please refer to page 5 for diagram of parts.
1.
Turn the power switch
off
and unplug the machine from the
electrical
outlet.
2.
Wash the carafe,
lid
and filter holder in a
mixture
of
mild
detergent
and
water. Rinse each thoroughly.
3.
To rinse the inside of the machine, follow steps for brewing espresso
using water only.
How To Brew Espresso
Please refer to page 5 for diagram of parts. First unwind the electrical cord
from the bottom of your machine.
Filling
the
Water Tank...
1.
2.
3.
4.
Turn the selector control knob to the center ‘0’ or OFF position and turn
the on/off switch OFF.
Fill the glass carafe with cold water to the
designated
marking for the
desired number of servings of espresso. Never use warm or hot water
to fill the water container. Note: If you are making cappuccino, refer to
page
8
for the prop
*For
2 servings,
filI water up to the 2 cup marking.
er water measurements.
*For 4 servings,
fill
water up to the 4 cup marking.
Remove the water tank boiler cap and pour the water into
the
water
tank. Do not fill to the top of the tank or there will not be enough area to
generate
steam.
CAUTION:
Do not pour water into the tank white the
machine is on.
Check to make sure power switch is off. Do not pour more than 10
ounces of water into the tank.
Screw the boiler cap back on top of the water tank. Make sure It is
on tight.
Preparing the Coffee...
1.
Remove the filter holder by grabbing the filter handle and
sliding
l/4
to
the left. The filter holder
will
now release.
2.
Place the
filter
basket in
the
filter holder. See
figure 1.
3.
Fill with fresh fine ground espresso coffee to the 2
or 4 cup mark of the
filter
basket. Do not fill above
the 4 cup markings. Clean any excess coffee from
the rim of the filter holder. This will assure proper
fit under the brew head.
ATTENTION:
a. Do not pack coffee.
b. Do not overfill the
filter
basket. This
might
cause clogging or over flow.
FIGURE 1