Filter
Top Products
Important, To Reset Auto Brew at Preset Time
This coffeemaker will NOT automatically come on again
the
next
day if you leave the switch in the AUTO position after its last use.
This is a safety feature. Each time you choose to use Auto brew,
you must slide the switch to OFF and
then
to AUTO.
To make sure Auto brew is set, check the Auto Off light. If the light
is off, Auto brew is set. If it is on, slide the switch to OFF and then
to AUTO.
Before Using Your
Mr.
Coffee
Make sure your fist cup of coffee is as good as can be by cleaning your Mr.
Coffee coffeemaker before you use it the first time. Just follow these simple
steps:
1.
Wash the decanter, lid and brewing funnel in a mixture of mild detergent
and water. Rinse each thoroughly.
2.
If you have a clock model, set the clock. The digital clock on the SRX55
model must be set
first,
before
the
coffeemaker will operate. See
instructions for setting the clock.
3.
Slide the brewing funnel into place and then follow steps
#4
through
#6
in the “HOW TO BREW COFFEE’ section. This will clean the inside of
your coffeemaker.
4.
When the brew cycle is finished, turn your coffeemaker off. Discard
the
water in the decanter and rinse the decanter and brewing funnel.
Your coffeemaker is now ready to use.
Brewing Coffee
If the display on the
digltal
clock timer, model
SRX55
Is flashing, the
clock has not been set and the cof’feemaker will not operate. See page
6
for setting
the
clock.
1.
Remove the brewing funnel. Place one Mr. Coffee filter inside.
2.
Place coffee into the paper filter according to the coffee measurement
chart found on the next page.
3.
Se sure the paper filter is properly centered before sliding the brew
funnel back into position.
4.
Fill the decanter with tap water to desired capacity as marked on the
side of the decanter. (1 cup equals 5 ounces.) To brew 10 cups of
coffee, fill the decanter
to
the bottom of the sifver band.
5.
Lift the water tank door and pour the water into the tank. Close the water
tank door and place
the
empty decanter onto
the
warmer plate.
CAUTION:
Tb
decanter
must be fully In
place
on the warmer
pbte.
The position of the decanter controls the flow of coffee into the decanter.
If it is not in place, the coffee in
tie
brewing funnel
will
overflow
onto
the
warmer
plate.
7