Filter
Top Products
STOW CMS-94SCONCRETE MIXERS — PARTS & OPERATION MANUAL — REV. #2 (08/04/06) — PAGE 23
2. As the drum rotates, use a shovel (Figure 20) to place the
cement mix inside the drum, add water as required. Be careful
to only place the
tip
of the shovel inside the drum.
Figure 19. Mixing Drum Positioning
3. Placing the shovel all the way inside the drum (Figure 21) will
cause the shovel to strike the blades. This condition will make
the shovel rotate, and could cause injury to personnel.
NEVER place hands inside the mixing drum while it is
rotating.
Operation
1. To position the tub, make sure the mixer is placed on firm
level
ground,
then
pull up
on the
dump latch
(Figure 19) and turn
the
hand wheel
until the tub is at the desired position. Once
the tub is at the desired position,
pull down
on the dump latch
to lock the tub in position.
STOW CMS-94S CONCRETE MIXER — OPERATION
Stopping the Mixer (Gasoline)
1. Push the main
start/stop
switch (Figure 22) inward to stop
the engine.
Stopping the Mixer (Electric)
1. Place the electric motor's
ON/OFF
switch (Figure 23) in
the OFF position.
2. Disconnect the electric motor's extension cord from its
power source.
3. Clean drum of all debris and foreign matter.
2. Place fuel shut-off lever in the OFF position.
3. Clean drum of all debris and foreign matter.
Figure 20. Filling Mixing Drum
Figure 21. Filling Mixing Drum
Figure 22. Start/Stop Button (Stop Position)
Figure 23. Electric Motor ON/OFF Switch
(OFF Position)
CAUTION:CAUTION:
CAUTION:CAUTION:
CAUTION:
NEVER stand in front or behind the mixing
drum while it is being placed in the dump
position. Stay clear of the mixing drum while
it is being positioned.