Filter
Top Products
CX-HF SERIES MIXERS — OPERATION AND PARTS MANUAL — REV. #3 (03/11/08) — PAGE 7
■
In emergencies
always
know the location of the
nearest phone or
keep a phone on the job site
.
Also know the phone numbers of the nearest
ambulance
,
doctor
and
fire department
. This
information will be invaluable in the case of an
emergency.
Maintenance Safety
■
NEVER lubricate components or attempt service on a running
machine.
■
ALWAYS allow the machine a proper amount of time to cool
before servicing.
■
Keep the machinery in proper running condition.
■
Fix damage to the machine immediately and always replace
broken parts, or missing decals.
■
Dispose of hazardous waste properly.
■
DO NOT use food or plastic containers to dispose of
hazardous waste.
Emergencies
■
ALWAYS know the location of the nearest
fire extinguisher
and first aid kit.
CX-HF SERIES HAND MIXERS — RULES FOR SAFE OPERATION
■
DO NOT spray water onto electric motor. Do not expose
equipment to rain or wet conditions. Water entering the
equipment will increase the risk of electric shock.
■
Double-insulated tools are equipped with a polarized plug
(one blade is wider than the other). This plug will fit on a
polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install a polarized outlet. Do not change the plug
in any way. Double insulation eliminates the need for the three-
wire grounder power cord and grounded power supply system.
■
AVOID body contact with grounded surfaces such as pipes,
radiators, ranges, and refrigerators. There is an increased
risk of electric shock if your body is grounded.
■
When operating a power tool outside, use an outdoor
extension cord marked "W-A" or "W". These cords are rated
for outdoor use and reduce the risk of electric shock.
■
Remove adjusting keys or wrenches before turning the tool
on. A wrench or a key that is left attached to a rotating part of
the equipment may result in personal injury.
■
Do not overreach. Keep proper footing and balance at all
times. Proper footing and balance enables better control of
the equipment in unexpected situations.
■
Do not force any tool. Use correct tool for your application. The
correct tool will do the job better and safer at the rate for which
it is designed.
■
Do not use the equipment if switch does not turn on or off. Any
equipment that cannot be controlled with a switch is dangerous
and must be repaired.
■
Check for misalignment or binding of moving parts, breakage
of parts, and any other condition that may affect the operation
of the equipment. If damaged, have the equipment serviced
before using. Poorly-maintained equipment can cause
accidents.
■
Do not use the equipment in an environment with potentially
explosive atmosphere. Do not mix any solvents or solvent-
containing substances with a flash point of below 69° F (21° C).
■
Make sure that the current voltage indicated on the rating
plate corresponds to the main power supply.
■
Position the cord clear of the rotating mixing paddle. Do not
wrap the cord around arm, wrist or other body parts. This can
cause injury.
■
Start up or run down the machine in the mixing container only.
Make sure that the mixing container is placed in a firm and
secure position.