Filter
Top Products
EM-70 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (008/10/04) — PAGE 33
EM-70 PLASTER/MORTAR MIXER — MAINTENANCE (MIXER)
Lug Nut Torque Requirements
It is extremely important to apply and maintain proper wheel
mounting torque. Be sure to use only the fasteners matched
to the cone angle of the wheel. Proper procedure for attach-
ment of the wheels is as follows:
1. Start all wheel lug nuts by hand.
2. Torque all lug nuts in sequence. See Figure 35. DO NOT
torque the wheel lug nuts all the way down. Tighten each
lug nut in 3 separate passes as defined by Table 9.
3. After first road use, retorque all lug nuts in sequence.
Check all wheel lug nuts periodically.
Figure 35. Wheel Lug Nuts Tightening Sequence
NEVER!
use an pneumatic air gun
to tighten wheel lug nuts.
NOTE
STNEMERIUQEREUQROTERIT.01ELBAT
eziSleehW
ssaPtsriF
SBL-TF
ssaPdnoceS
SBL-TF
ssaPdrihT
SBL-TF
"2152-0204-5356-05
"3152-0204-5356-05
"4152-0206-05021-09
"5152-0206-05021-09
"6152-0206-05021-09
Table 8 (Tire Wear Troubleshooting) will help pinpoint the
causes and solutions of tire wear problems.
WEAR PATTERN SOLUTION
CAUSE
Center Wear
Over Inflation
Adjust pressure to
particular load per
tire manufacturer.
Edge Wear Under Inflation
Make sure load does
not exceed axle rating.
Align wheels.
Side Wear
Adjust pressure to
particular load per
tire manufacturer.
Loss of chamber
or overloading.
Toe Wear
Incorrect toe-in
Align wheels.
Cupping
Out-of balance
Check bearing adjust-
ment and balance tires.
Flat Spots
Wheel lockup &
tire skidding.
Avoid sudden stops
when possible and
adjust brakes.
TABLE 9.TIRE WEARTROUBLESHOOTING