Filter
Top Products
PAGE 14 — MVC-82VH/VHW PLATE COMPACTOR • OPERATION AND PARTS MANUAL — REV. #1 (04/25/08)
COMPONENTS (COMPACTOR)
4
3
5
2
8
67
1
10
9
WATER TANK
(MVC-82VHW ONLY)
Figure 1. Plate Compactor Controls and Components
Figure 1 shows the location of the basic controls and
components of the MVC-80VH/VHW Plate Compactor. The
function of each control is described below:
1. Water Tank Cap (VHW Only) – Remove this cap to
add water to the water tank.
2. Fuel Tank Cap – Remove this cap to add fuel.
3. Lifting Bale – When lifting of the compactor is required
either by forklift, crane, etc., tie rope or chain around
this lifting point.
4. Handle Bar – When operating the compactor use this
handle bar to maneuver the compactor.
5. Gasoline Engine – This plate compactor uses a
HONDA GX160U1SM12 engine. Refer to the HONDA
owner's manual for engine information and related
topics.
6. Belt Cover – Remove this cover to gain access to the
V-belts. NEVER run the compactor without the V-belt
cover. If the V-belt cover is not installed, the possibility
exists that your hand may get caught between the V-
belt and clutch, causing serious injury and bodily harm.
7. Vibrating Plate – A flat, open plate made of durable
cast iron construction used in the compacting of soil.
8. Vibration Case – Encloses the eccentric, gears and
counter weights.
9. Water Shut-Off Valve (VHW only) – Turn this valve
downward to let water flow from the water tank to the
water tube.
10. Water Tank (VHW only) – Holds 13.8 quarts of water
(removable, no tools required).