![](http://pdfasset.owneriq.net/9/fe/9fe23dc0-99d9-4015-b0e3-23ef4d3a29aa/9fe23dc0-99d9-4015-b0e3-23ef4d3a29aa-bgf.png)
Figure 3. Robin D1B40T92040 Diesel Engine Components
Figure 3 illustrates the location of the major components for the ROBIN D1B40T92040 diesel engine. The function of each
component is described below
ROBIN DIESEL
scs
DIESEL
ROBIN
2
3
4
5
6
7
8
9
10
11
FRONT VIEW
REAR VIEW
11
1
BASIC ENGINE
1. – Type of engine
starting method. Alternate type would be electric start
(ignition key).
2. – Remove this cap to add
diesel fuel to the fuel tank. Make sure cap is tighten
securely. over fill. Fuel tank capacity is 5.3
quarts (5.0 liters)..
3. – Remove the air cleaner
cover, then lift this cover (the one with decals on it) to
gain access to the engine lifting straps.
4. – Prevents dirt and other debris
from entering the fuel system. Remove wing-nut on
top of air filter cannister to gain access to filter element.
5. – This lever is connected to
the throttle control which is located on the compactor
handle bar. This lever to controls engine speed.
6. – Remove this cap to add oil
to the engine crankcase. Read dipstick to determine if
oil level is low. over fill lever to control engine
speed. Engine oil capacity is 1.6 quarts (1.55 liters).
7. – Secure these engine mounts
to the compactor frame. Tighten securely.
8. Oil Suction Filter – Remove this bolt to gain access
to the internal oil suction filter. Service the oil suction
filter as recommended in the maintenance section of
this manual.
9. Oil Drain Plug – Unscrew plug to drain oil from engine
crankcase. Dispose of oil in a safe manner.
10. – Connect this shaft to the input of the
transmission.
11. – Used to reduce noise and emissions.
12. – Contains information about the
engine.