2
W415-0158 / E / 02.19.04
Pg
2-4 INTRODUCTION
Warranty
General Instructions
General Information
Care of Glass & Plated Parts
Shipping Bracket
5 LOCATION & CLEARANCES
6-12 DIRECT VENT SPECIFICS
MODEL GDS60
Vent Lengths/Air Terminal Locations
Special Installation Example
Offset Installation Example
Horizontal Terminations
Orifice Replacement
Top Vent to Rear Vent Modification
Venting Parameters
Wall & Ceiling Protection
Horizontal Venting Installation
Vertical Venting Installation
Stove Vent Connection
Mobile Home Installation
13-14 B-VENT SPECIFICS
MODEL GS60
Chimney Installation
'B' Vent Installation
Combustion Air
Adding Vent Sections
Flashing and Storm Collar Installation
Pg
14 GAS INSTALLATION
15-16 FINISHING
Logo Placement
Front Cast Installation
Glass Door Closing & Opening
Log Placement
17-18 OPERATION / MAINTENANCE
Spill Switch
Venting Action Check
Operating Instructions
Maintenance
19 BLOWER INSTALLATION
19 ADJUSTMENTS
Pilot Burner Adjustment
Venturi Adjustments
Restricting Vertical Vents
20-21 REPLACEMENTS
Ordering Replacement Parts
Termination Kits
Replacement Parts
Accessories
22-23 TROUBLE SHOOTING GUIDE
24 SERVICE HISTORY
WARNING
• The stove is a vented gas-fired heater. Do not burn wood or other materials in this stove.
• Adults and especially children should be alerted to the hazards of high surface temperatures and should stay
away to avoid burns or clothing ignition. Supervise young children when they are in the same room as the
stove.
• Due to high temperatures, the stove should be located out of traffic and away from furniture and draperies.
• Clothing or other flammable material should not be placed on or near the stove.
• Any safety screen or guard removed for servicing must be replaced prior to operating the stove.
• It is imperative that the control compartments, burners and circulating blower and its passageway in the
stove and venting system are kept clean. The stove and its venting system should be inspected before use
and at least annually by a qualified service person. More frequent cleaning may be required due to excessive
lint from carpeting, bedding material, etc. The stove area must be kept clear and free from combustible
materials, gasoline and other flammable vapours and liquids.
• Under no circumstances should this stove be modified.
• This stove must not be connected to a chimney flue pipe serving a separate solid fuel burning appliance.
• Do not use this stove if any part has been under water. Immediately call a qualified service technician to
inspect the stove and to replace any part of the control system and any gas control which has been unde
r
water.
• Do not operate the stove with the glass door opened, cracked or broken. Replacement of the glass should be
done by a licensed or qualified service person.
• Do not strike or slam shut the stove glass door.
• This fireplace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple
supplied by Wolf Steel Ltd.
NOTE: changes, other than editorial, are denoted by a vertical line in the margin.
TABLE of CONTENTS
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE