Filter
Top Products
ENGLISH 4
OPERATING YOUR MARGARITA MANIA™
Now that you have pre-cleaned and reassembled your MARGARITA MANIA™, making
perfect frozen drinks is both easy and fun!
Follow the steps 2 through 4 in Pre Use Preparation and Assembly, on pages 2 and 3, to
prepare the MARGARATOR MANIA™ for use.
A. Fill the pitcher with your favorite liquor, mix or fruit (or you may choose to select to
follow one of the recipes included in this booklet). Put the lid on the pitcher, and set
the pitcher in place (refer to page 3 pre-use preparation and assembly if needed, for
proper placement and insertion).
B. Open the ice compartment, and remove any foreign objects. Add enough cubed ice
to fill but not exceed the max fill line.
C. Close the ice compartment by lining up the lid hinges with the hinge acceptor on the
motor base as instructed on page 2 (Pre Use Preparation and Assembly). Your lid
should close and snap shut with the lid fitting
smoothly into place.
D. Select the desired blending and ice button you desire
and push in. The buttons are located on the front of
your MARGARATOR MANIA. ™
Reading buttons left to right
1. Power On/Off
*2. Ice Shaver
3. Blender
*4. Ice Shaver and Blender B
Location of locking tabs on clear ice
cover
Location of locking tab for removing ice
tray
C
* Allow ice to shave to desired consistency.
E. Wait until all moving parts have stopped and the unit is un-plugged from the
socket before moving or cleaning the unit.
IMPORTANT INFORMATION and TIPS
This unit is not a commercial unit. DO NOT leave unit running for more than 3
minutes at a time.
After each use, please allow 5 minutes for unit to cool before using again, to
prolong the life of the Margarita Mania™.
Should the unit operate slowly, please turn off unit and wait 10 minutes for unit to
cool down before operating. Also, at this time, make sure the shaving area is
free of debris.
DO NOT use the blending pitcher to blend ice. The hopper on top is for ice
shaving.
CLEANING
1. After using your MARGARITA MANIA™, disconnect from electrical outlet.
Remove plug by gripping the plug body and pulling out of the outlet. Never yank
or twist cord to unplug the unit.