NuTone NS6500 Series Ventilation Hood User Manual


 
4
WIRING CONNECTIONS
All wiring connections must comply with local codes and the unit
must be properly grounded.
1. Makesureboxconnectorissecure.
2. Refer to FIGURE 8. Make wiring connections.
3. Replaceelectricalboxcoverandsecurewithscrew.
LAMP INSTALLING
OR REPLACEMENT
1. Depress sides of light diffuser until tabs of diffuser disengage
from slots in hood. Remove diffuser.
2. Install(2)60wattmaximum,TypeA-19bulbs.
3. Replace difuser in hood by depressing sides and engaging tabs
in slots in hood.
FILTER INSTALLATION
AND REPLACEMENT
1. Forductedoperation,installthealuminummeshlter.Fornon-
ductoperation,installthenon-ductedlter(ModelWA65F,sold
separately).
2. Refer to FIGURE 9.Thelterslidesintochannelsattheback
of the hood, on either side of the fan compartment, and snaps
under the spring clips near the front of the fan compartment.
MAINTENANCE
FILTERS
IMPORTANT:Thealuminumltershouldberemovedoncemonthly
and washed in hot detergent water. Rinse in clear, warm water and
shakeoffexcessmoisturebeforereplacing.Theltermayalsobe
cleaned in your dishwasher.
IN A NON-DUCTED INSTALLATION: Replace lter every 3-6
months as needed.
CLEANING
The hood should be wiped off occasionally both inside and outside
using warm water, mild dish detergent and a soft cloth. Never use
scouring powders, steel wool pads or any other abrasive cleaners
whichwilldestroythehood’snish.
REPLACEMENT PARTS
Should replacement parts be required, please indicate hood model
number and appropriate part number. Contact your NuTone dealer
orNuToneat:
IntheU.S.contact:
NuTone, Inc., 4820 Red Bank Road, Cincinnati, OH 45227
(1-800-543-8687)www.nutone.com
IntheCanadacontact:
Broan-NuTone Canada, Inc., 1140 Tristar Drive, Missis-
sauga,Ontario,L5T1H9(1-888-882-7626)www.nutone.ca
FIGURE 9
FIGURE 8
SUPPLY WIRING
WHT
BLK
GREEN
OR BARE
(GROUND)
GREEN GROUND
SCREW
WHT
HOOD WIRING
BLK