NuTone QTXN110SL Ventilation Hood User Manual


 
Page 4
MODEL QTXN110SL
SERVICE PARTS
99043589D
Key No. Part No. Description
1 97016466 Housing
2 97016450 Duct Connector-6”
3 98010102 Wiring Plate
4 99170245 Screw, #8-18 X .375
5 97017086 Wire Panel/Harness Assembly *
6 99020284 Blower Wheel
7 99080598 Motor
8 99100491 Isolator (4 req’d)
9 97017083 Motor Plate & Control Assembly *
10 99250959 Washer #8 (4 req’d)
11 99260558 Nut, Hex Lock #8-32 (4 req’d)
* 97017452 Blower Assembly *
(includes key nos. 6 thru 11)
12 97016968 Grille Assembly *
(includes key nos. 13, 14 & 17)
13 99140199 Grille Spring (2 req’d)
14 99111345 Lens
15 99111293 Spacer (2 supplied)
16 SQTHB1 Hanger Bar Kit
17 99271344 Sensor Wire Harness
18 99420665 Thumbscrew, #8-18 x .375
TAB
INSTALL GRILLE
6. Finish ceiling.
Install ceiling material. Cut out around housing.
7. Plug in wiring.
Plug wiring into the proper receptacles.
8. Attach grille to
housing.
Squeeze grille springs and
insert them into slots on
each side of housing.
10. Remove light lens.
Carefully insert a small
at-blade screwdriver be-
tween grille and lens. Pry
lens out.
9. Push grille against
ceiling.
11. Install light bulbs.
Purchase an incandescent
bulb (100W max.) and a
4W incandescent night-
light bulb and screw them
into their sockets. Replace
lens.
WARRANTY
Replacement parts can be
ordered on our website.
Please visit us at
www.nutone.com
SERVICE NOTE
To remove Blower Assembly: Unplug motor (7).
Remove thumbscrew (18) from motor plate (9)
ange. Find the single TAB on the motor plate (lo-
cated next to the receptacle). Push up near motor
plate tab while pushing out on side of housing.
Or insert a straight-blade screwdriver into slot in
housing (next to tab) and twist screwdriver.
NUTONE THREE YEAR LIMITED WARRANTY
NuTone warrants to the original consumer purchaser of its products that such products will be
free from defects in materials or workmanship for a period of three years from the date of original
purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT
NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PAR-
TICULAR PURPOSE.
During this three-year period, NuTone will, at its option, repair or replace, without charge, any product
or part which is found to be defective under normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS AND TUBES. This
warranty does not cover (a) normal maintenance and service or (b) any products or parts which have
been subject to misuse, negligence, accident, improper maintenance or repair (other than by NuTone),
faulty installation or installation contrary to recommended installation instructions.
The duration of an implied warranty is limited to the three-year period as specied for the express
warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above
limitation may not apply to you.
NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE’S OPTION, SHALL BE THE
PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. NuTone SHALL
NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT
OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation may not
apply to you.
This warranty gives you specic legal rights, and you may also have other rights, which vary from
state to state. This warranty supersedes all prior warranties.
To qualify for warranty service, you must (a) notify NuTone at the address or telephone number
stated below, (b) give the model number and part identication and (c) describe the nature of any
defect in the product or part. At the time of requesting warranty service, you must present evidence
of the original purchase date.
Broan-NuTone LLC Hartford, Wisconsin www.nutone.com 888-336-3948
* Parts not listed are included with Assembly.
Order service parts by “Part No.” - not by “Key No.”