Filter
Top Products
- 12 -
PREPARE THE HOOD (CONT’D)
(NON-DUCTED HOODS ONLY)
8. Carefully slide the upper decorative flue down
inside the lower flue.
9. Carefully place the decorative flues into the
recessed area of the range hood top.
Note: Air vents must be up.
ROOMS WITH 10-FOOT CEILINGS
Rooms with 10-Foot ceilings require flue
extension model RFXN5304,
available from your local dealer.
10. Discard upper flue supplied with
product. Replace with flue ex-
tension RFXN5304.
11. Secure the recirculation plenum
to the upper flue with (4) flat head
screws.
INSTALL THE HOOD
Note: At least two people will be
required to mount the hood.
1. Align the rectangular opening on the back
of the hood with the wall-mounting bracket.
Gently lower the hood until it securely en-
gages the bracket.
2. Level the hood and secure with (2) mount-
ing screws under the hood. Use drywall
anchors provided if wall studs or framing
are not available.
3. Raise the upper flue until its holes align
with holes in the flue mounting bracket (lo-
cated on ceiling).
4. Secure the flue with (2) mounting screws.
PLENUM
4 FLAT HEAD
SCREWS
3.9 x 9.5mm
MOUNTING SCREWS
MOUNTING
SCREWS
(4.8 x 38mm)
UPPER FLUE
MOUNTING
BRACKET
WALL FRAMING
RECTANGULAR
CUTOUT