Filter
Top Products
I M P O R T A N T
INSTALLATION INSTRUCTIONS FOR
OMEGA INDUSTRIES, INC.’s
METAL LINER AND DECORATIVE WOOD HOOD
Before installation may begin, the following components are required:
• Fan unit, part number 90026WHI1
• Blower unit, part number 90039WHI1
• Ducting System • Metal Liner • Decorative Wood Hood
A. The Wood Hood is composed of three separate components:
1. The decorative Hood Front.
2. Optional galley rail (shipped unattached).
3. T-shaped Metal Liner, Figure 2.
NOTE: T-shaped liner shipped with unit as standard. Rectangular
shaped metal liner available for on-site Wood Hood construction, Fig-
ure 4.
4. The ventilation system (power module and ducting system) is
not included and must be purchased separately.
B. Installation: Metal Liner – T-Shaped, Figure 3
1. Measure up 6 1/8 from the bottom of adjacent cabinets. Scribe
a level line horizontally across depth of both cabinets.
2. Raise Metal Liner so that bottom edge of liner is level with
scribed lines. Use four (4) #8 x 1/2” screws provided to attach
liner to adjacent cabinets through pre-drilled holes in liner. (If
metal liner is not flush to cabinet sidewalls, it may be neces-
sary to use a filler piece to avoid bowing the liner.) Locate
studs and place two #8 x 1 1/4”, supplied, through rear of
liner.
C. Installation of Omega Industries, Inc.’s decorative
Wood Hood:
1. Slide decorative hood front into position over T-Shaped liner
and between adjacent cabinets. Install the hood front by ad-
joining to adjacent cabinets through the front frames using (4)
#8 x 2 1/2” screws (not provided).
Form OME-03 12/2002 ©2002
Omega Industries, Inc.
Figure 1
Figure 2
Figure 3