Filter
Top Products
D. Installation – Galley Rail
1. An unattached optional Galley Rail assembly may be enclosed
with the decorative hood front. The Galley Rail should be at-
tached as shown in Figure 1. NOTE: All screw holes should
be pre-drilled. Exercise caution if nailing to avoid damage.
E. Installation of Rectangular Metal Liner (Figure 4) (used for on-
site construction of decorative Wood Hood)
1. Measure down 23 7/8” from top of adjacent cabinets. Scribe a
level line horizontally across depth of both cabinets.
2. Place bottom edge of 3/4” x 4” x 11 1/4” long wood filler block
along scribe line. Make sure filler block is tight against back
wall, Figure 5.
3. Use four (4) #8 x 1” screws, supplied, and fasten the two wood
filler blocks to adjacent cabinets.
4. Raise liner so bottom is level with scribed lines. Fasten liner to
filler block by driving four (4) #8 x 1/2” screws, supplied, through
pre-drilled holes (2 per side) in liner, Figure 6.
5. Locate studs and place #8 x 1 1/4” screws, supplied, through
rear of liner into stud.
F. Installation of Power Units
90026WHI1 Fan Unit – see installation instructions enclosed with
each Power Unit.
90039WHI1 Blower Unit - see installation instructions enclosed with
each Power Unit.
Source for all parts listed:
Your local distributor or: Omega Industries, Inc., 1010 Rowe Street,
Elkhart, IN 46516 •
574-295-5353 or 574-295-5329(fax)
Form OME-03 12/2002 ©2002 Omega Industries, Inc.
Figure 4
Figure 5
Figure 6