Oster BLENDERS Blender User Manual


  Open as PDF
of 10
 
5. Place threaded jar nut or threaded jar skirt over
blade and jar (Note: If there are slots on top of
collar, line them up with notches on jar.) Place the
threaded jar nut or threaded jar skirt on jar and turn
it clockwise to tighten. (Figure 4)
6. Place jar assembly onto base. (Figure 5)
7.
Line up tabs of jar with tabs on blender base.
Make sure the tab of the jar on the
left
side is in the
back of the tab of the blender base and the tab of
the jar on the right side is in front of the tab of the
blender base. Make sure jar is seated into position.
(Figure 6)
8. Place ingredients into jar.
9. Place lid with feeder cap on jar.
10. Plug the power cord into a 120 Volt
AC electrical outlet.
11. Slide switch to HIGH or LOW. (If your model does
not have a slide switch, push HIGH or LOW button.)
12. Push desired speed and blend ingredients
to desired consistency.
13. Press OFF to stop the blender.
14. To use PULSE, select HIGH or LOW. Push PULSE
and hold down for desired length of time. Release
PULSE and allow blade to stop. Repeat cycle as
desired.
Blending Tips
•Putliquidsinthejarfirst,unlessarecipesaysotherwise.
•Crushingice:Crush6icecubesorapproximately2cups
of ice at a time.
•Donotremovethelidwhileinuse.Removefillercapto
add smaller ingredients. (Figure 7)
•Cutallfirmfruitsandvegetables,cookedmeats,fishand
seafood into pieces no larger than 3/4 inch (1.8 cm) to
1 inch (2.5 cm). Cut all kinds of cheeses into pieces no
larger than 3/4 inch (1.8 cm).
•Thisblenderwillnotmashpotatoes,whipeggwhitesor
substitute dairy toppings, mix stiff dough or grind raw
meat.
Hot Foods
•OpentheFillerCaptoventsteam.TiltFillerCapawayfromyou.
Keephandsawayfromthecoveropeningtopreventpossibleburns.
•Whenworkingwithhotliquids,removeFillerCapandstartblendingat
a low speed. Then move to a faster speed. DO NOT add liquid over the 4 cup
(1 liter) level.
54
Using Your Blender
1. Clean blender according to the instructions in the “Cleaning and Storing
Your Blender” section.
2. Turn jar upside down so the small opening is at the top. (Figure 1)
3. Place sealing ring over jar opening. (Figure 2)
4. Place blade into jar. (Figure 3)
12345678910 11 12
EASYCLEAN
PURÉE CREAM CHOP WHIPMIX GRATE BLENDSHRED GRINDLIQUEFY
ICE CRUSH
LOW HIGH
16-Speed
LOW HIGH
1234567891011121314
EASYCLEAN
BEAT PURÉE CREAM CHOP WHIPMIX MINCEGRATE BLENDSHRED GRINDLIQUEFY ICE CRUSH
14-Speed
LOW HIGH
12-Speed
LOW HIGH
12345678910
EASY CLEAN
PURÉE CHOP WHIPMIX GRATE BLENDGRIND LIQUEFY
ICE CRUSH
10-Speed
LOW HIGH
12345678
PURÉE CHOP MIX PULSE LIQUEFY SHAKE SMOOTHIEICE CRUSH
8-Speed
12345678910111213141516
PULSE
EASY CLEAN
STIR BEAT PURÉE CHOP WHIP MIX
ICECRUSH
GRATEBLEND SHREDGRIND MASH LIQUEFY FRAPPÉ
Figure 1 Figure 2 Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
 previous next