Panasonic NC-EH40P Hot Beverage Maker User Manual


 
15
Part Names and Handling Instructions
How to Open/Remove
To open, press the depression in the
opening lever, and lift the lid.
Lid opening lever
Depression
Lid release
lever
To remove, push on the lid release lever,
hold the lid opening lever, and pull the lid
out and up diagonally.
To close
Press down on the lid until it clicks.
To attach
Insert the lid at an angle.
Overheating Protection
If an empty container is heated, the overheat safety function (which prevents an empty
container from being heated) will be activated. The power will be shut off automatically to
prevent the problems that may occur due to overheating.
Overheating, the display shows
LEDs flashing alternately
If an empty container is heated, an odor will be emitted and the container may be discolored.
Cause
• Less than the minimum water level in the
container was boiled.
After water is added, the lid might be left open.
How to cancel the display
Pour water into the container, and
press the
key.
Notice
Operating NC-EH40_EN.indd 15 11/7/07 3:57:17 PM