Panasonic NC-EH30P Hot Beverage Maker User Manual


 
21
Cleaning start
Maintenance
When scale has adhered
Clean with Citric Acid
once every two or
three months
 Make sure that the mesh filter is attached to the container.
 Put citric acid in the inner container.
Amount of citric acid to be used at one time:
80 g (two packages) or seven level tablespoons.
The citric acid is available from an authorized dealer. (Model No: SAN-80N)
* Follow the directions for cleaning printed on the citric acid package.
* Since the citric acid used for cleaning is a food additive, it is harmless to humans.
 Add water to the maximum water level mark, and
mix the citric acid and water well. Close the lid.
Citric acid
 Connect the plug immediately after stirring and press the key
more than 3 seconds.
Indications will note
when cleaning ends.
Cleaning time (approx.)
NC-EH40P: 50 Min.
NC-EH30P: 42 Min.
NC-EH22P: 35 Min.
 Dispense some water, then unplug, remove the lid and throw away the hot water via
the “DRAIN” mark.
 Refill with water and boil it to remove the smell of the citric acid or lemons.
Then throw the hot water away in the same way as in step .
To remove any discoloration from the area above the maximum water level, rub the inside lightly
with a wet sponge.
If the discoloration cannot be removed by rubbing, clean the inner container several times using
citric acid or lemons.
Cautions
Use only our citric acid to clean this thermo pot.
Do not fill with water above maximum water level.
Fill the container only with tap water (do not fill with hot water). Hot water may spout out causing burns.
End of cleaning
Lit Flashing
Operating NC-EH40_EN.indd 21 11/7/07 3:57:56 PM