Filter
Top Products
Troubleshooting
tf...
White
or
glittering
flakes floating
in
the hot water.
Boiling sounds
become louder.
Hot water has
odors of chlorine.
Hot
water has
an
unpleasant
odor.
Hot water
comes
out by itself.
Hot water
does
not
flow out smoothly.
Electric
dispense
Air
dispense.
Hot water
does
not
dispense.
Electric
dispense
Air
dispense
The indicator
lights
flash alternately.
The indicator liqhts
flash
alternateli
and displayed Hl.
Possible
cause
oThe
cause of this
is "scale".
(See
P.14)
It is not flakes
of
fluororesin.
.
Water with
a
large
content of minerals in it
such as mineral water or ionised water, is
more
likely
to cause
a scale or
white layer
in the hot water.
oWhen
"scale"
adhered,
boilinq
sounds
become
louder.
oOdors
of chlorine remain
depending on
the
amount of chlorine
in tao water.
oWhen
the unit is new, resin
used
in manufacture
may
give
off
a mild odor.
This will
disappear
with
use.
olf
the
unit
is
placed
on surfaces such as a
vinvl
sheet,
the
odor
mav
be carried
over
into
the water.
oWater
has
been added above maximum
water level.
oThe
mesh
filter
may be clogged with "scale".
(See
P.'14)
oRubber
gaskets
may
be spoiled.
olt
is harder to
dispense
if the keeo-warm temoerature
or
water level is low.
oThe
automatic
lock has
been engaged.
rThe
Push
plate
lock lever is locked.
oThe
lid is
opened.
oOverheating
protection
has
been activated
(See
P.9)
Replacement
of
Parts
Specifications
Please
avoid using the unit
in
such conditions.
.
lf
the unit
is not
used during cold conditions,
make
sure to empty
it
of
water. The water left in the inner
container
may freeze
causing
damage.
Before
calling a service supplier,
please
check the following
possible
causes.
oThe
indicator lights may flash
alternately
by adding boiling
water
or the way the
water
is supplied.
oWhen
the
inner
container is cleaned with
citric
acid, citric
acid
have
built up on the bottom.
o
lf the
problem
is not fixed
after checking the above
possible
causes, or
if
you
think
something
is
strange,
dtsconnect the
body
plug
from
the unit. Wait at least 10
seconds and
then re-connect
the
plug.
oThe
semi-transparent
inner
part
inside
the lid may become
yellowish.
This
does
not
affect operation
of
the
unit.
oThe
rattling noise in
the
lid is
made by
small
ball-shaped
components
which
prevent
water from flooding
out
if the
unit topples over.
olf
the room temperature is
very high, the
outside of
the main
unit
may reach
about
50"C.
oThis
is
malfunction of the sensor.
Contact
the
stores
where
you
purchased.
Rubber
gasket
set
(A,
B,
C)
Replace
gaskets
if
they crack, lose their
pliancy
or,
for any other
reasons which
allow steam to escape
from
between
the
container and
the lid.
Remove lid,
unscrew
4 tapping
screws and
remove
the
lid
cover. Exchange the
gaskets
and then
place
the
lid
cover back and secure with the tapping screws.
Mesh filter
Replace the filter, if foreign materials which
clog the
filter
cannot be
removed, even
after
you
scrub
with a cleaning brush, etc.
The
filter
can be
removed by
pulling
firmly on
it.
Consumable
parts
are available
from
an authorized dealer.
Part name Part No,
Rubber
gasket
set
APH65-536-0S
Mesh filter APB97-480-0U
Model
No.
NC.PF3OPV
Power
supply
Local
supply
Power
consumption
700 w
Average
power
consumption
in keeping warm
(approx.)
{Amount
of water: maximum
\
\
Room
temperature: 20=C
I
at 98
28 Wh
at 90
23 Wh
at 80
20 wh
at 60
14 Wh
Dimensions
(when
the handle is tilted)
Height
(approx.)
31.1
cm
Width
(approx.)
22.2
cm
Depth
(approx.)
29.4
cm
Weight
(including power
cord)
(approx.)
2.4 kg
Rated
capacitv
(approx.)
3.0
L
Under certain conditions, such as at
very high
altitudes and
in intense cold, the unit may not function
properly.
16
17