Filter
Top Products
- 11 -
How to Operate
D. PROGRAM LOCK
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
1
Keep the door closed.
☛ Digital Display Window must be blank.
2
Press Program Lock Button for five seconds until “PROG”,“P” and
“L” appear.
☛ “PROG”, “P” and “L” will appear.
PROG LOCK
PROG
In Program Lock mode:
• The oven is started by pressing the desired Memory pad. There is no need to press Start pad.
• Opening the door cancels the remaining time on the program.
• The oven can not be programmed until the program lock is released.
◆
2 or 3 stage heating
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
Follow steps 1 to 5 on page 10.
11
PROG
A
STAGE DEF
Example:To program cooking at DEFROST power for 1 minute and at HIGH power for 2 minutes into Memory pad “5”
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCK IS ACTIVATED! (see below on this page)
DO NOT OPEN THE DOOR WHILE PROGRAMMING!
In Program Unlock mode:
• Oven reverts to a two-touch operating mode (Memory pad + Start pad).
• Repeat and interrupt feature are operational.
• Memory pads can be programmed.
• Tone loudness and length can be changed.
INSTRUCTION
DIGITAL DISPLAY WINDOW
PAD
1
Keep the door closed.
☛ Digital Display Window must be blank.
2
Press Program Lock Button for five seconds until “PROG” and “P”
appear.
☛ “PROG” and “P ” will appear.
PROG LOCK
PROG
6
Press Power Level Selector pad once.
☛ The power level for 2nd stage will be indicated, 2nd Stage Heating
Indicator “2” will start to blink.
POWER
11
PROG
A
STAGE HI
2
7
Set the desired heating time using Timer Dial.
☛ The set heating time will appear.
Note:up to 15 min. on HI or MED, 60 min. on LOW, DEF or HOLD
11
PROG
A
STAGE HI
2
8
Press Program Entry Button again.
☛ “PROG” and 2nd Stage Heating Indicator “2” will stop blinking. The
total time for both stages will appear. This means that you have
completed programming.
PROG
11
PROG
A
STAGE HI
2
• Three seconds later, Digital Display Window will go blank.
◆
To activate Program Lock:
◆
To release Program Lock: