Filter
Top Products
66
Installing the distance guides
The appliance is supplied with two distance guides which should be
installed on the lower part of the housing to prevent from pushing the
appliance too close to the wall. Appliance may also be installed without
the spacers; however, this may increase power consumption.
Cleaning
After installation, wipe the appliance clean with warm water.
Connecting the mains plug to the household mains socket
After the appliance is plugged, all symbols will appear for a moment, and then the startup values will appear as -18 °C on
freezer setting indicator and 5 °C on fridge setting indicator.
All buttons on the control panel are touch-operated. (Only press to activate the button you want to operate.)
Notes:
• Cooling may take longer in the summer months or at other times when the room temperature is higher.
• If you need to unplug the refrigerator, wait at least 10 minutes before you plug it back in again. If not, you might damage
the compressor.
Ambient room temperature
You’ll nd your refrigerator’s climate classication on the rating plate in the left side of the fridge compartment. It shows
the room temperature the appliance is designed to work in.
Climate classication Permitted ambient temperature
SN (Extended Temperate) +10 °C to 32 °C
N (Temperate) +16 °C to 32 °C
ST (Subtropical) +16 °C to 38 °C
T (Tropical) +16 °C to 43 °C
For saving energy
1. Install the refrigerator in a dry, cool and well-ventilated room. (Please refer to Page 5 for dimensions and clearance.)
2. The combination of drawers and shelves that result in the largest in volume and the most efcient use of energy for the
refrigerator.
• Remove the freezer drawers.
• Attach the drawers and shelves in the refrigerator to the positions illustrated on the section of “Parts” (P.7).
3. Do not over ll the refrigerator to allow the air to circulate.
4. Open the doors only when necessary and as briey as possible.
5. Occasionally clean the ventilation openings at the bottom of the refrigerator with a vacuum cleaner, etc.
(Take care not to damage the refrigerant pipe inside the cover.)
6. When setting to Super Freeze Mode, Flash Freeze Mode or Super Cool Mode, power consumption will be increased.
Installation (continued)