Filter
Top Products
Preparations
Installation / How to replace room lamp
• The refrigerator must
be located in the place
where there is good air
circulation. There should
be a space between the
top of the refrigerator
and the ceiling at least
30 cm as well as the
space between the back
of the refrigerator at
least 10 cm and the side
of the refrigerator and
the wall at least 5 cm.
• Do not locate the
refrigerator in a humid
place as rust may form
and may cause electric
leakage.
• Do not locate the refrigerator
exposing to direct sunlight as the heat
and sunlight will increase the temperature.
• When moving or shifting the refrigerator, remove all
trays and check to be sure that there is no water in
the refrigerator.
• In case of placing the refrigerator on an uneven
surface, adjust the leveling stand to make the
refrigerator stands stably.
• If there is no ground wiring plug in refrigerator, it
should be connected with ground connection to
prevent hazard from electric leakage.
5 cm
10 cm
30 cm
Installation
How to replace room lamp
When replace room lamp, shall be
disconnect supply cord to prevent electric
shock.
1. Disconnect supply cord.
2. Remove room lamp cover from back
side (following picture )
3.
Replace proper lamp (E14 240V 15W max.)
surely.
4. When finish replacing room lamp,
assembly room lamp cover by reverse
proper method.
use your finger
to push the
back locking
tab to unlock
room lamp
cover
room lamp
cover
Remark
1. Be careful while replacing a room lamp, you may get injured from touching a hot lamp.
2. Do not press front side when removing room lamp cover.
7
How to use
NR-BU302-342.indd 7 1/12/10 7:13:56 PM