Filter
Top Products
r
lif
lo
uJ
z
This
oven monitors its
operation and displays
a
Failure
Code in the Display Window
when
a
problem
occurs.
Whal to do when a failure
code appears:
NOTE:
Above codes shown in Display Window
do not indicate all the
possible
failures on the unit.
1. Unplug the oven
before cleaning.
2. Keep
the
inside
of the oven clean. When food
spatters or
spilled
liquids
adhere to oven walls, wipe with
a damp cloth.
N4ild detergent may be
used
if
the oven
gets
very dirty. The
use of harsh detergent
or abrasives
is not
recommended.
The
air
intake
splash
guard/light
diffuser can
be
removed for
cleaning
by
removing
the center
plugs
from the two
plastic
rivets. The top is held
by two tabs.
Wash in warm dishwater and replace.
3. The outside oven surfaces should be
cleaned with a damp
cloth. To
prevent
damage to the operating
parts
inside the
oven, water
should
not
be allowed to seep into the ventilation
openrngs.
4. lf the Control Panel becomes wet,
clean
with
a sott, dry cloth.
Do not
use
harsh
detergents or abrasives on Control Panel.
When cleaning the Control Panel, leave
oven door open to
prevent
oven from accrdentally
lurnrng on.
After cleaning, touch
STOP/RESET
Pad
to clear Display
Window.
5.
lf
steam
accumulates inside
or around the outside of the oven
door,
wipe wilh
a soft cloth. This may occur when the
rnicrowave
oven
is
operated under high humidity conditions
and in no way indicates mallunction of the
unit.
6. Clean off
grease
and dust on bottom surfaces
otten. Use
warm
detergent solution.
7. Cleaning inside the oven outer
panel
and
inside
the oven
base should be
performed
only by
qualified
service
personnel
after taking
precautions
to drain all stored voltage
potential.
The
bottom
is
accessible by removing the center section of
the base and the
power
and sensor control
areas are
within
the outer wrap around housing. Avoid using liquids
and
cleaning solutions
in these
areas. Use a dry sott bristle brush
or a cloth. Reolace all
oarts-Do
not connect the
oven
to the
electricity supply
il
any
parts
are not reassembled.
CODE
CAUSE WHAT TO DO
F01
'Overcooked
lood
.Temperature
of exhaust
air too
high.
'Press
STOP/RESET Pad to stop
beep.
'Wait
for
oven to cooi down and
reset.
'lt
a
flame is
Dresent,
do
not
open oven door.
'lf
normal operation does
not resume,
call the service agent with
information of tailure code.
F33-34
'Defective
sensor circuit
.
Unplug the oven and
wait more
than
10
seconds before reconnecting.
'lf
normal operation does not resume, cali the
service agent
with the information
of
tailure
code.
F44
'When
a
pad
was
pressed
for more
than 30 seconds
"Detective
pad
or control circuit
-18-