Filter
Top Products
General Information
4
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
Form No. Z2304
Rev. 05.22.10
Refrigeration and Temperature Control
Each zone has been factory set to maintain the
desired temperature specified when ordered. The
factory set storage temperatures are as follows:
Refrigerator — 34° to 38° F
White wine — 50° to 55° F
Red wine — 60° to 65° F
Adjusting the Temperature
The temperature control in the left compartment is
located on the left side of the evaporator fan panel.
The temperature control in the right compartment is
located on the top rear partition wall. You will need
a flat head screwdriver to turn the adjusting screw
on the control. Make small adjustments until the
desired temperature is achieved.
■
Colder Temperatures:
Turn the adjusting screw clockwise (to the right).
■
Warmer Temperatures:
Turn the adjusting screw counterclockwise
(to the left).
■
Temperature Control “OFF”:
Turn the adjusting screw completely counter-
clockwise to the “O” position until a click is
noted.
The condenser fan motor turns off and on with
the compressor. The evaporator fan motor runs
continuously. The partition wall fan cycles with
the damper assembly.
NOTE:
Cabinet Temperatures lower than 34° will not allow
for proper defrosting of the evaporator coil. If
defrosting is necessary, remove product from the
cabinet and turn the control adjusting screw to the
OFF position until coil is defrosted.
Cleaning the Cabinet
Use a mild detergent and water to clean the inside
and outside of the cabinet. Dry thoroughly. Never
use a scouring pad or abrasive cleanser.
NOTE: An industrial strength, commercial cleaner
can be used to clean the outside of painted
cabinets.
Cleaning the Condenser
The condenser (located behind the front grille
cover) should be inspected every 30 days and
cleaned, if necessary.
Use a long handled, stiff brush to clean the dirt
from the front surface of the condenser. Keeping
the condenser free from dust and dirt will ensure
efficient operation.
Failure to keep the condenser clean will cause a
loss in condensing unit efficiency, and may damage
the compressor.
CAUTION:
Do not bend the fins while brushing the
front of the condenser.
Recommended Cleaning Agents
JOB CLEANING AGENT* COMMENTS
Routine Cleaning Soap, ammonia, detergent Apply with sponge or cloth.
Can be used on all finishes.
Fingerprints and smears Areal 20, Lac-O-Nu, Lumin Wash, Provides barrier film to minimize
O’Cedar Cream Polish fingerprints. Can be used on all finishes.
Stubborn stains and Allchem Concentrated Cleaner, Rub lightly, using dry or damp
Discolorations Samae, Twinkle, Zud Restoro, cloth in the direction of polish
Grade F or FFF Italian Pumice, lines on the stainless steel.
Whiting or Talc, Liquid Nu Steel,
Copper’s or Revere Stainless Steel
Cleaner, Lumin Cleaner, Sta-Clean,
Cameo Copper Cleaner, Allen Polish
Highlite, Penny-Brite, Copper Brite
* Use of propriety names is intended only to indicate a type of cleaner and does not constitute an endorsement.Omission of
any proprietary cleaner does not imply its inadequacy. All products should be used in strict accordance with instructions on
the package. NOTE: Do Not Use Steel Wool or Scouring Pads to clean stainless steel.