Filter
Top Products
KEG CAPACITY 2 Keg 3 Keg 4 Keg
NUMBER OF DOORS 2 2 3
DIMENSIONS Length Ins. (mm) 60” (1524) 72” (1829) 84” (2134)
Cabinet Depth Ins. (mm) 24
1
/8” (613) 24
1
/8” (613) 24
1
/8” (613)
Height Ins. (mm) 34
1
/2” (876) 34
1
/2” (876) 34
1
/2” (876)
NO. OF DISPENSING HEADS 1 1 2
NO. FAUCETS 2 2 2
CONDENSER UNIT H.P.
1
/4
1
/3
1
/3
RUNNING LOAD - AMPS 5.9 7.5 7.5
SHIP WT lbs. (kg) 340 (155) 400 (182) 440 (200)
INTERIOR Fourteen gauge stainless steel sills are reinforced with a 12 gauge angle bracket that extends from one
end of the insulated base to the other. The floor pan is 20 gauge, type 304 stainless steel. The walls and
ceiling are 20 gauge galvanized steel.
EXTERIOR All Models: The top is 20 gauge stainless steel. The back is 20 gauge galvanized steel.
Bottom is 20 gauge stainless steel.
Black Models: Doors, front and sides are 20 gauge black powder coated steel.
Stainless Models: Doors, front and sides are 20 gauge stainless steel.
REFRIGERATION R-134a capillary tube-type. Aluminum fin and copper tube evaporator coil. Forced air into dispensing
head. Adjustable temperature control. Self-defrosting. Pull-out condensing unit for service and cleaning.
VENTILATION Front ventilated.
ELECTRICAL 115 Volt, 60 Hz., 1 Phase AC. Furnished with three prong, six foot rubber cord.
Contact Perlick for other voltage/frequency requirements.
PLUMBING Floor drain
3
/4” female taper pipe exits out right bottom or end for drip pan waste only. Evaporator
condensate has been plumbed to a condensate pan located in the compressor housing.
INSULATION Foamed-in-place polyurethane; 2” walls, 1
1
/2” top and floor.
OPTIONAL ACCESSORIES • Optional Dispensing Heads • Leg Set • Door Locks • Keg Couplers
• Caster Sets • Shelf Kit • Faucet Locks
SPECIFICATIONS
BLACK DS2KP DS3KP DS4KP
STAINLESS STEEL DS2KS DS3KS DS4KS
Form No. Z2025A
Rev. 12.05.03
2
Installation and Operating Instructions
Sizes and Specifications, Direct Draw Dispensers - Self-Contained
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
MODEL NUMBERS