Philips HR1371 Blender User Manual


 
If the mains cord is damaged, it must be replaced by Philips, a
service centre authorised by Philips or similarly qualied persons in
order to avoid a hazard.
Always unplug the appliance from the mains before you assemble,
disassemble, clean or make adjustments to any of the accessories.
Never immerse the motor unit in water or any other liquid, nor
rinse it under the tap. Only use a moist cloth to clean the motor
unit.
Never let the appliance run unattended.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
Do not allow children to use the appliance without supervision.
This appliance is intended for household use only.
Do not exceed the quantities and processing times indicated in the
table.
Do not process more than three batches without interruption. Let
the appliance cool down to room temperature before you continue
processing.
Never touch the blades when the appliance is plugged in. The
blades are very sharp.
If the blades get stuck, unplug the appliance before you remove the
ingredients that block the blades.
Noise level: Lc = 70 dB [A]
Overheat protection
This appliance is equipped with overheat protection. If the appliance
overheats, it switches off automatically. Unplug the appliance and let it
cool down for 5 minutes. Then put the mains plug back into the wall
socket and switch on the appliance again. Please contact your Philips
dealer or an authorised Philips service centre if the overheat protection is
activated too often.
,
,
,
,
,
,
,
,
,
,
,
,
,
ENGLISH 7