Filter
Top Products
Due to the fact that the magnetic coupler end is polarized, it can only be attached to the heat control one way. When properly aligned,
the plug will magnetically attach itself to the heat control. If positioned upside down, it will not attach.
Important: The magnetic cord was designed to detach easily from the multi-cooker. As a result, if it is bumped or touched
during use it could possibly detach causing the unit to stop heating. Avoid contact with cord during operation. If contact oc-
curs, verify that the cord is still properly connected.
4.
Plug the multi-cooker into a 120v AC electrical polarized outlet only.
5.
Set the heat control at the temperature speci ed in the recipe. The pilot light will go out when selected temperature is reached. During
cooking, the pilot light will go on and off indicating temperature is being maintained.
6.
Simmer: To nd the simmer point (just below boiling), heat pan at 400˚ until the food boils then turn the control down until the light
goes out. If you don’t want food to boil, start at Warm and increase heat until you reach the simmer point.
7.
When cooking is complete, turn heat selector to OFF. Remove plug from wall outlet and then remove magnetic coupler end from heat
control. Allow appliance to cool and detach heat control from multi-cooker before cleaning.
*dip-it is a registered trademark of Ecolab, Inc.
4