Filter
Top Products
User manUal | 9
Plan where the ductwork will be located. Install proper-sized duct work, and roof or wall
cap, depending on where you will be venting your hood. Recommended and most com-
mon installations are shown in the venting diagrams above. Adjust your measurements
to accomodate heights of ceilings, cabinets, or rangetops.
wall hood installation
step 1
Install anchors and screws
Markings you’ll need:
♦ center line of installation area
♦ location of studs
♦ horizontal line 28” - 36” above the cook
top (this is where the bottom of the range
hood will be)
Use one panel of the cardboard ship-
ping box to trace an outline of the
hood.
♦ Place the cardboard panel against the
range hood and trace an outline
♦ Find the center point of range hood (di-
rectly between mounting holes) and mark
it on the cardboard panel
♦ Find the mounting points on the hood
and mark them on the panel
♦ Transfer the panel to the wall, lining the
bottom of panel to the horizontal line
♦ Line up the center point of the panel with
center point on the wall
♦ Find mounting points on the cardboard
and poke holes through it, marking where
you will mount the hood to the wall.
♦ Predrill holes where your mounting marks
are, then insert wall anchors and mount-
ing screws