Filter
Top Products
10 |
PROLINE
RANGE HOODS
USER MANUAL | 11
step 3
wall hood installation
wall hood installation
Hang hood and connect
step 2
Install ceiling bracket
♦ Place the chimney bracket against the ceiling
♦ Find the center point of the bracket and mark
it
♦ Line the bracket center point with the center
point on the wall
♦ Mark the locations of bracket holes on wall
♦ Drill holes into the wall where you’ve marked
♦ Install wall anchors into these holes
♦ Screw ceiling bracket into place
♦ Chimney will mount on this bracket
♦ Carefully hang the hood on the wall, attaching it
to the studs using the screws already in place
♦ Line up bottom of range hood with your bottom
line on the wall
♦ Tighten and anchor the hood to the wall
♦ Make sure to anchor the hood to a stud so the
wall can support the weight of the range hood
♦ Attach your ductwork to the top of the hood
♦ Duct tape into place
♦ Find the three pronged plug and connect to an
electrical outlet
step 5
Install grease filter
step 4
Install chimney
♦ Take off protective laminate coating
♦ Place the chimney on top of range hood base
♦ Make sure the chimney is facing the correct
direction (the vertical vent should be on the
top)
♦ Secure the lower portion of the chimney to the
base of the hood
♦ Attach the chimney to the ceiling mounting
bracket
♦ Screw the chimney into place on both sides
♦ Now the chimney is secured to the ceiling and
wall
♦ Peel off any protective tape or film.
♦ Pop spring loaded filter into place
♦ That’s it! Now you’re ready to try out your new
range hood