Filter
Top Products
This product is warranted by RadioShack against manufacturing defects in
material and workmanship under normal use for ninety (90) days from the date
of purchase from RadioShack company-owned stores and authorized RadioShack
franchisees and dealers. For complete warranty details and exclusions, check with
your local RadioShack store.
RadioShack Customer Relations
200 Taylor Street, 6th Floor, Fort Worth, TX 76102
04/04
©2004. RadioShack Corporation.
All rights reserved. RadioShack and
RadioShack.com are trademarks
used by RadioShack Corporation.
49-1003
07A04
Printed in China
Mount the motion detector so it points
slightly downward to obtain maximum
coverage.
1. Attach the motion detector to the
mounting bracket using the supplied
machine screw.
2. Use the supplied mounting screws to
mount the motion detector (with bracket)
on a wall, about 5 - 6 feet high.
3. Slide 1/2 on the back of the motion
detector to 1 for instant triggering and
maximum sensitivity, or to 2 to trigger
the alarm only after two movements are
sensed in the coverage area.
mounting your motion detector
limited 90-day warranty
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules
. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Consult your local RadioShack store or an experienced
radio/TV technician for help.
• If you cannot eliminate the interference, the FCC
requires that you stop using your motion detector.
• Changes or modifications not expressly approved
by RadioShack may cause interference and void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules
.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
FCC information
1. Slide 1/2 to 1.
2. Press and hold down TEST until the
motion detector’s LED flashes twice,
and then release it.
3. Wait 20 seconds, and then walk in front
of the motion detector. Its LED lights
when movement is sensed. If necessary,
reposition the motion detector for the
desired coverage area.
4. Press TEST when you are finished.
testing your motion detector
1 / 2
TEST