Filter
Top Products
SAFETY
ELECTRICAL REQUIREMENTS AND GROUNDING INSTRUCTIONS
CAUTION - ALL MODELS
In Case of an Electrical Failure
If for any reason a gas control knob is turned ON and there is no electric power to operate the
electronic igniters on the cooktop burners, turn OFF the gas control knob and wait 5
minutes for the gas to dissipate before lighting the cooktop burner manually.
To light the cooktop burners and grill manually, carefully hold a lighted match to the burner
ports and turn the gas control knob to HI. During a power failure, you can manually light the
standard cooktop burners and grill only, but each must be lit with a match.
If the grill is left on and power is restored, the grill will relight.
DO NOT attempt to light the two left burners manually. These burners are equipped
with the ExtraLow® feature and cannot be lit manually.
See Pages 11 and 29 for additional information on manually lighting the burners.
Section One: General Safety Instructions
PLEASE READ CAREFULLY
All Cooktop models and the Wok require an elec-
trical circuit rated at 120 volts, 60 Hz., 15 Amps.
For personal safety, this appliance must be
connected to a properly grounded and
polarized electrical power supply.
Always disconnect the electrical plug from the wall
receptacle before servicing this unit.
See Installation Instructions for electrical
requirements and grounding instructions.
DO
NOT
UNDER
ANY
CIRCUMSTANCES
CUT
OR
REMOVE
THE
SEPARATE
GROUND
WIRE
OR
THE
THIRD
(GROUND)
PRONG
FROM
THE
POWER
CORD
PLUG.
It is the personal responsibility and obligation of
you, the user, to have this appliance connected to
the electrical power supply in accordance with the
National Electrical Code and/or applicable local
codes and ordinances by a qualified electrician.
It is recommended that a dedicated circuit servic-
ing this appliance be provided.
!
Page 2