Filter
Top Products
7
Turning off the timer alarm:
At the end of the cooking time the hob will beep steadily for
2 minutes. Press any key to stop the alarm.
Deactivating the timer:
Make sure that none of the cooking zones has been selected.
Press the timer and ‘–‘ keys simultaneously. The timer display
will go out.
Child Lock Function
This allows the control panel to be locked to prevent any
accidental use.
IMPORTANT: The child lock functions (activating and
deactivating) can only be used when the hob has just been
switched on: a red dot should show in all of the cooking
zones (Fig.2-19).
Activating the child lock:
Switch on the hob. Press the lower right cooking zone ‘+’ key
and ‘–‘ key simultaneously (the hob will beep) then press
the lower right ‘+’ key once again. The hob will beep and ‘L’
flashes in each of the zone displays (Fig.2-20). The hob is now
locked. The child lock will remain on until it is unlocked. This
includes switching the hob on and off and also if there is an
interruption to the power supply.
Note: If a cooking zone is hot when locked, then ‘L’ and ‘H’
will flash alternately.
Unlocking for cooking purposes:
Press and hold both the lower right cooking zone ‘+’ key and
the ‘–‘ key simultaneously. The ‘L’ in each of the digital displays
will be replaced by a ‘0’ and a flashing dot. After switching off
the hob, the child lock function will remain activated.
Note: If a cooking zone is hot then ‘0’ and ‘H’ will flash
alternately.
Deactivating the child lock:
Switch on the hob. Press the lower right cooking zone ‘+’ key
and ‘–‘ simultaneously (the hob will beep) then press the ‘–‘
key once more. The hob will beep and the ‘L’ in each of the
zone displays will go out and the hob will switch off. When
the hob is switched on again it is now unlocked.
Automatic Shutdown
If the touch controls are continuously activated for longer
than 10 seconds then the hob will shut down automatically.
The hob will beep for 10 seconds, and the displays will show
‘Er03’ (Fig.2-21) as long as the touch controls are activated.
Note: If the cooking zone is hot then an ‘H’ will flash
alternately along with the error code.
Automatic Safety Shutdown
If any of the cooking zones has been left on by mistake the
safety shutdown control will switch them off automatically
after the time limit shown in the table is reached (Table 2-1).
Art No. 050-0008 BI ceramic operating limits table
Table 2-1
ArtNo.317-0010 60 Error code
Fig.2-21
ArtNo.317-0007 60 Setting the zone timer
Fig.2-19
ArtNo.317-0009 60 Child lock on
Fig.2-20