Filter
Top Products
15
When reassembling the Wok burner, turn over
the large base ring and find the ‘D’ shaped area.
Turn the head until the ‘D’ matches the one on
the burner base. Turn the head over and place it
on the burner base. To fit the small inner burner,
find the larger electrode notch in the burner rim.
Line this up with the white ignition electrode and
place the inner burner on the large base ring.
Now fit the two trim rings, making sure that they
are sitting down properly.
Grill
The face of the grill burner will darken with use -
this is perfectly normal. Any fat or grease will
burn off. Do not try to clean it - the small holes
could get blocked and affect burner performance.
The grill pan and grid should be washed in hot
soapy water. Stubborn particles may be removed
from the grid by using a nylon brush.
Control Panel and Doors
Avoid using any abrasive cleaners including
cream cleaners, e.g. Cif, on brushed Stainless
Steel surfaces. For best results use a liquid
detergent e.g. Domestos Multi Surface Cleaner.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean
hot soapy water - but take care that no surplus
water seeps into the appliance. Wipe with a
clean dampened cloth then polish with a dry
cloth. The oven doors should only be cleaned
with a soft cloth wrung out in clean hot soapy
water.
Cookers with window doors
On some models the oven door front panel can
be taken off so that the glass panels can be
cleaned. If the top edge of the oven door of your
cooker has a line of holes and there are screws
in the side edges then it can be taken apart for
cleaning.
Move the cooker forward to gain access to the
sides (see the ‘Moving the cooker’ section of
these instructions).
Open the oven door slightly and remove the front
panel fixing screws from the door sides (two
each side).
some window doors only
Carefully lift off the outer door panel. The inside
face of the glass panels can now be cleaned -
take care not to disturb or wet the door
insulation. Please note that the door is triple
glazed but the inner two panels are fixed and
should not be separated. After cleaning carefully
refit the outer door panel and replace the side
fixing screws.
The Main Oven
Cleaning is easier if carried out while the oven is
still warm. Before cleaning, cover the burner to
prevent the burner holes becoming blocked.
The inside of the oven and inner door panel can
be cleaned using any cleaner bearing the
Vitreous Enamel Association (VEA) label.
Take care not to disturb the oven thermostat
temperature sensor at the top of the oven
opening.