Filter
Top Products
9
User Maintenance
The hand-held unit shall be detached
from the power supply cord before
cleaning. The shaver shall not be
used until it has dried.
Cleaning your shaver:
This is an important step!
Remington recommends cleaning
your shaver after every use for opti-
mal performance.
Daily:
1. Make sure your shaver is off and
unplugged.
2. Press the two Lift & Wash release
buttons. Now switch the shave
back on for better cleaning and
let warm water rinse through the
opening.
3. After cleaning, switch the shaver
off. Leave the shaver open for a
few minutes so that it can dry by
air circulation.
4. To clean the external surfaces of
the shaver, use a damp cloth. Do
not use strong detergents or other
chemicals.
5. To dry, wipe the surface of the
shaver with a dry towel. Do not
use a hairdryer or heater to dry the
shaver.
Weekly:
1. Make sure your shaver is off and
unplugged.
2. Remove the screens.
3. The cutters and the trimmer should
now be cleaned with the cleaning
brush.
4. Rinse the whole shaver head in
water.
CAUTION! Never use the brush on
the screens as damage may occur.
CAUTION! Never submerge the
shaver in water.
5. To clean the external surfaces of
the shaver, use a damp cloth. Do
not use strong detergents or other
chemicals.
6. To dry, wipe the surface of the
shaver with a dry towel. Do not
use a hairdryer or heater to dry the
shaver.
Replacing Screens and
Cutters:
It is very important to replace your
screens and cutters when neces-
sary to ensure a close, comfortable
shave without irritation. We recom-
mend they be replaced every 6 to 12
months.
A few signs that your screens and
cutters need replacing:
Irritation: As screens get worn, you
may notice that your skin feels more
sensitive after a shave.
Pulling: As cutters wear, your shave
may not feel as close and you may
feel your shaver is “pulling” the
hairs.
Wear-through: You may notice that
the cutters have worn through the
screens. To prevent inadvertent
damage to the cutters and screens,
do not attempt to remove them from
the head assembly unless you are
replacing them. Removal instruc-
tions are included with the cutter and
screen replacement packages.
The replacement part for the F-710
and F-720 is model SP-102.
To order shaver accessories call
800-231-8793, visit
www.remington-products.com,
or visit your local retailer.
The shaver is
a washable
shaver, the
hand-held part
of which may
be cleaned
under water.
8
32400_F-710/720_IB.indd 8-9 1/22/07 2:50:18 PM