Roper FGP320Y Range User Manual


 
Adjusting the oven temperature control
Does your oven seem hotter or colder than your
old oven? The temperature of your old oven may
have shifted gradually without you noticing the
change. Your new oven is properly adjusted to
provide accurate temperatures. But, when
compared to your old oven, the new design may
give you different results.
If, after using the oven for a period of time, you
are not satisfied with the temperature settings,
they can be adjusted by following these steps:
1.
Push in and turn the Oven Temperature
Control Knob to the off position. Pull knob
straight off and flip it over.
2. Loosen the locking screws inside the control
knob. Note the position of the notches.
3. To lower the temperature, hold knob handle
firmly and move the tooth a notch clockwise.
Each notch equals about 10°F (5°C).
4. To raise the temperature, hold knob handle
firmly and move the tooth a notch counter-
clockwise. Each notch equals about 10°F
(5°C).
Tighten the locking screws and replace the
control knob.
Broiling
The broiler drawer is located below the oven
door. Always broil with the oven door closed.
1. Pull the broiler drawer open and tilt the door
panel down.
2. Place broiler pan grid so grease can drain
down ribbing and through slots into lower part
of the broiler pan. See picture.
Drain slot Rib Front
3. Before the broiler is turned on, place food on
broiler pan and position the broiler pan at one
of the three levels. Refer to a reliable cook-
book for broiling chart.
Side view
13